全国服务热线:

15853163650
您当前的位置:首页 > 新闻动态 > 公司动态
    联系我们

    CONTACTS US

    济南皓晖建材有限公司,总部位于中国泉城——山东济南,是一家专业生产销售石塑电梯门套,仿大理石电梯门套的专业厂家。皓晖建材在电梯门套生产行业很多年,凭着优质的产品质量和完善的售后服务,在全国各地都有我们的工程案例。

    我们本着“以质量求生存 ,靠管理出效益,凭信誉赢口碑,以实干筑辉煌”的经营理念,公司将立足于当代建材现代化发展前沿,依靠科技、勇于探索,以优质产品优良服务、信誉与广大用户携手共创辉煌。

    联系电话: 15853163650

    工厂地址:山东济南章丘区(欢迎广大客户来厂勘察)

公司动态

COMPANY NEWS

电梯门套线养护剂操作标准方法

2017-01-05 14:49:50 文章来源:www.jnhaohui.com

  以烘箱或者瓦斯枪烘干电梯门套线,一些公司电梯门套线使用养护剂时为了节省成本,并没有事先烘干电梯门套线而直接使用养护剂,以致养护效果不佳。
In the oven drying or the gas gun lift line, some companies use elevator door line maintenance agent in order to save costs, and without prior drying lift Mentao line directly using a curing agent, so that the effect of poor maintenance.
事实上,烘干电梯门套线实属必要,其原因是:烘干电梯门套线可除去电梯门套线孔隙的水分,养护剂才能顺利的渗透到足够深度而具有深层的养护功能。
In fact, it is necessary to lift the drying line, the reason is: the drying line can remove the elevator elevator door line pore water curing agent can be successfully penetrated deep enough and has deep maintenance function.
烘干电梯门套线时应注意:瓦斯枪在电梯门套线上移动速度要控制好,如速度太快,瓦斯枪喷出的热源传导给电梯门套线表面的温度不够高,则无法有效除去电梯门套线孔隙内的水分。若瓦斯枪移动过慢,集中在某一点,则会让电梯门套线表面温度过高,严重时造成电梯门套线表面膨胀破裂。
Should pay attention to the elevator door line: drying gas gun control in the elevator door line speed, if the speed is too fast, the heat conduction of gas gun sprayed to the surface of the elevator door line temperature is not high enough, it can not effectively remove the pore water in the elevator door line. If the gas gun moving too slow, concentrated at one point, will make the elevator door line surface temperature is too high, resulting in serious surface lift line expansion rupture.
电梯门套线须回温至40摄氏度才能使用养护剂,其原因是温度过高,溶剂挥发过快,养护剂提早在电梯门套线表面硬化,导致渗透深度不够,养护剂的深层养护效果很差,水斑物质即可渗到目视范围之内。
The elevator door line should be back to the temperature to 40 degrees Celsius in order to use the curing agent, the temperature is too high, too fast solvent evaporation, curing agent on the surface of the elevator door line early hardening, resulting in penetration depth is not enough deep curing effect curing agent is poor, water can seep into the spot material within visual range.
使用适量的养护剂,使用养护剂的量一定要足够,否则电梯门套线吸收不够,无法产生养护效果。
Use appropriate amount of curing agent, curing agent with the amount must be sufficient, otherwise the lift line absorption is not enough, can not produce the effect of maintenance.
以毛刷涂抹均匀,使养护剂能很均匀渗透电梯门套线表面的每一点,以避免发生局部使用量大,养护强,局部却使用量不足,发生病变因素浸入的状态。
With the brush evenly, the curing agent can be uniformly surface lift Mentao line every point, to avoid local usage and maintenance, but local usage, disease factors immersion state.
以赶紧抹布擦拭残余的养护剂,避免残余养护剂才电梯门套线表面硬化,破坏电梯门套线表面光泽度。
In order to quickly dishcloth residual curing agent, curing agent to avoid residual lift line surface hardening, damage the surface gloss of elevator door line.
静之保养24小时,才可以进行工程,养护剂若尚未完成硬化,其养护效果不佳,可能导致养护失败。
Maintenance of static 24 hours before the project can be carried out, curing agent, if not yet completed hardening, its poor maintenance, may lead to maintenance failure.
上面讲解的便是关于我公司产品的相关信息,希望您满意小编的讲解。我们用满腔的热情、无限的激情对待工作和客户,我们愿意用勤奋的努力和您一起共铸美好明天!
The above is about the company's products on the relevant information, I hope you satisfied with the small series of explanations. We are filled with enthusiasm and passion towards work and customers, we are willing to use the hard work and you create a better tomorrow!