济南皓晖建材电梯门套厂家分享电梯门套的安装步骤，下面就给大家详细分享。
Jinan hao CDH building materials manufacturer of elevator door cover share the elevator door cover installation steps, the following details to share to everyone.
第一、电梯门套表面需要简单处理，表面应干燥，含水不大于8%。

First, the elevator door cover surface need simple processing, surface should be dry, water cut is not greater than 8%.

第二、石电梯门套安装前先挑选好的材质。
Second, the elevator door cover to choose good material before installation.
第三、对安装的结构表面清理，放水平线、垂直线。
Third, cleaning the surface of the structure of installation, put in vertical and horizontal.
第四、用台钻打眼、每块板上、下打眼，孔位打在板中间，孔径为 8毫米，深度为12毫米。
Fourth, with bench drill, and punch a hole on every board, the drilling, hole location in the middle of the plate, the aperture is 8 millimeter, depth of 12 mm.
第五、用膨胀螺栓把角架固定，再把挂件固定在角架上。

Fifth, with the expansion bolt cover the fixed frame, again to hang on the Angle of the rack.

第六、电梯门套开槽，用云石胶把其固定在挂件上。
Sixth, the elevator door cover slot of the fixed with marble glue on the pendant.
第七、立面垂直，光面平整，接缝平直，接缝宽度，偏差允许2毫米。
Seventh, vertical elevation, smooth level off, the seam straight, seam width, 2 mm deviation allowed.

第八、全部安装完后，要对电梯门套表面一次性清洁干净。

Eighth, after the installation, all one-time clean to the elevator door cover surface.