第一步：对墙面进行平整预处理，中间要用到，尺子、切割机、锤子、钉子。
The first step: the surface of the smooth pretreatment, in the middle to use, ruler, cutting machine, hammer, nails.
注意点：墙面要做到平整，有坑洼的地方使用发泡胶填充，或者直接打上木架。
Note: the wall to achieve smooth, eliminate the use of styrofoam filled, or a direct hit on the gallows.
第二步：根据实际尺寸进行仿大理石装饰板的切割。
The second step: according to the actual size of the imitation marble decorative plate cutting.
注意点：在拼接的过程当中要从一边开始，不限制那边，边缘根绝实际尺寸裁剪。

Note: in the splicing process should start from the side, does not limit the side edge according to the actual size of cutting.
第三步：将拼接好的板材取下，然后用结构胶进行涂抹。两种涂抹方式1.全部均匀的整板涂抹。2.定点涂抹。
The third step: the splicing of a good plate removed, and then use the structural adhesive for painting. Two all the way to apply 1 evenly coated. 2 fixed point smear.
注意点：在涂抹的时候尽量均匀，避免不平整的结合！
Note: in the smear of the time as far as possible to avoid uneven combination!
第四步：边缘和仿大理石线条搭配使用，能够使设计的整体效果更加完美！
The fourth step: the edge and the imitation marble line with use, can make the design of the overall effect is more perfect!
注意点：不能画蛇添足，根据场合进行使用。
Note: can not use superfluous, according to the occasion.
第五步：修边机的使用。这个过程看的就是师傅技术了，有一些年轻没经验的师傅修边做的非常糟糕，影响整体的效果。
The fifth step: the use of trimming machine. This process is to see the master of technology, there are some young and inexperienced master to repair the edge of the very bad, affecting the overall effect.
注意点：尽量找个有经验的师傅去做这个工作。修边会做到锦上添花的效果。
Note: try to find an experienced teacher to do the work. Trimming can achieve the effect of icing on the cake.
第六步：最后撕去仿大理石UV装饰板材饰面的防护膜。
The sixth step: the last to tear off the imitation marble UV decorative plate facing the protective film.
注意点：不要用利器去除去封膜，慢慢的用手揭开封膜。
Note: do not use the weapon to remove the film, slowly open the sealing film.
。